Gemini GEM-P800 User Manual

Browse online or download User Manual for Safety Gemini GEM-P800. Gemini GEM-P800 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Usin
g
Your GEM-P800 Security System
ARMED
STATUS
GEMINI
1 2 3 4 5 6 7 8
Oi219c
page 1
Tuesday, September 16, 1997 08:24
Page view 0
1 2 3 4 5 6 ... 15 16

Summary of Contents

Page 1

Using Your GEM-P800 Security SystemARMEDSTATUSGEMINI 1 2 3 4 5 6 7 8Oi219c page 1Tuesday, September 16, 1997 08:24

Page 2 - Introduction

10Fire ProtectionFloorplanDraw a plan of your premises below.Oi219c page 10Tuesday, September 16, 1997 08:24

Page 3

Special FunctionsBy pressing A followed by the the appropriate key, (do not press simultaneously) these special functions and featurescan be enabled

Page 4 - 1 2 3 4 5 6 7

12The GEM-P800 is constantly monitoring its own components, as well as all critical services, such as AC power and the telephoneline, to insure that

Page 5

13System Troubles Keypad Beeps orFlashesZone lightONSystem TroubleConditionAction2 Beeps2 Fire Trouble A problem has been detected in the Fire Circ

Page 6 - Arming Your System

Your Installer has assigned a User 1 Code which can be used to not only Arm and Disarm the system, but also to enter the UserProgram Mode, where you

Page 7 - Emergency Conditions

Ambush Code - In the event that youare forced by an intruder to disarm yoursystem, this special code can be used todisarm the system, and simultaneou

Page 8

NAPCO LIMITED WARRANTYTHE FOLLOWING STATEMENT IS REQUIRED BY THE FCC.This equipment generates and uses radio-frequency energy and, if not installed an

Page 9

IntroductionCongratulations on your purchase of an advanced GEMINI-P800 Security System. Meticulously developed by a leadingmanufacturer of state

Page 10 - Fire Protection

3Important - Test Your System Weekly !1 Bell / Battery Test Test your bell or siren by pressingfollowed by . This will cause the bell, or siren to

Page 11 - Special Functions

ARMEDSTATUSGEMINI 1 2 3 4 5 6 7 8 4Keypad Controls and IndicatorsStatus Light will light when all zones are secureand system is ready

Page 12 - System Troubles

Arming Your System When Leaving1Before arming your system, make sure the green Status light is ON. This indicates that all of your protective zones ar

Page 13 - System Troubles

Protecting Yourself While at Home1 Before arming your system, make sure the green Status light is ON. This indicates that all of your protective zone

Page 14 - User Codes

Emergency Buttons The three sets of emergency buttons, if programmed, are always active whether the system is armedor disarmed. Discus

Page 15 - Glossary

Disarming Your System when Returning1 Enter your premises through the Entry/Exit door. The keypad will sound a steady tone to remind you to disarm the

Page 16 - NAPCO LIMITED WARRANTY

Preparing a Fire Escape PlanEven with the most advanced fire alarm system, adequate protection requires an escape plan.To prepare your plan, draw floo

Comments to this Manuals

No comments